3ch S006 Alloy Shark Rc Helicopter
Recently Viewed Flying Links
Learn To Fly
Flying Lessons
Aviation Schools
Helicopter Lessons
Helicopter Training
RC Helicopter, RC Airplanes
Flight Lessons
Flight Training
Helicopter Training
3ch S006 Alloy Shark Rc Helicopter
25 Comments
Learn to Fly, Easy Flying, Flying Lessons
- Our sponsor links have been Verified -Help Yourself with these Special Gifts
Learn To Fly - Flying Lessons
>RETURN TO TOP OF PAGE<
#1 by lachie360 on August 9th, 2011
Quote
i have one of these but it wont fly forward, the rear tail motor does not spin at all when i try to make it go forward but it works perfect when i try to go back wards, any help?
#2 by yoyoairsoft1411564 on August 9th, 2011
Quote
can it go outside?
#3 by MrSamus11 on August 9th, 2011
Quote
im retarded i have one yet i fail to land it every time
#4 by SuckMyMontage on August 9th, 2011
Quote
@checkplusauto Same happened to me, but with my Syma S107. I think the shaft is bent. Thanks xheli !
#5 by sb18121995 on August 9th, 2011
Quote
@checkplusauto Hey its quite simple even mine was doin da same. aftrwrds i realised that during takeoff if i press the forward stick slightly(as trimming didnt solve my problem) and then it took of nicely without moving in any direction.
#6 by sb18121995 on August 9th, 2011
Quote
how much time does the gyro take for stabilizing plzz answer
#7 by sb18121995 on August 9th, 2011
Quote
hey i have a alloy shark 3ch heli can i fly it outdoors? and when i take off the helicopter starts moving towards the back on the left hand side plz suggest…..
how much time does the gyro take?
#8 by 007FILBO on August 9th, 2011
Quote
This heli is not at all durable due to its cheap brittle plastic on the upper rotor shaft..i made a new piece from HPI plastic & it can now take some hits.. =)
but still very hard to control…if you want something easy to fly indoors with precision & good run time get a syma s107
#9 by ht448 on August 9th, 2011
Quote
Hi, my S006 has barely any forwar or backward momentom… an suggestions? i was thinking about putting a bigger prop on the back or bigger engine… Thanks
#10 by mondfurz on August 9th, 2011
Quote
Hab mir den gerade von euch bestellt müsste mittwoch da sein
#11 by RonnieSayers on August 9th, 2011
Quote
@gazket Set the TRIM
#12 by gangstaz4evah on August 9th, 2011
Quote
@gazket Under the directional control there’s two arrow buttons pointing left and right, press them accordingly (press right if it’s spinning anti clockwise and vice-versa.
#13 by gangstaz4evah on August 9th, 2011
Quote
@benwlkn After removing the canopy, you will found there’s something covered by wax, so what you have to do is scrape away the wax carefully. Then, adjust it with a small screwdriver, turn bit by bit per trial. Don’ t forget to mark down its original position before the turning it.
#14 by gazket on August 9th, 2011
Quote
I have one of these it’s hardly controllable I can get to hover but it constantly wants to spin on it’s axis. How do they fly forwards in a straight line or a large circle. ?
#15 by Esebi95 on August 9th, 2011
Quote
@viss3n
1 Up/Down
2 Left/Right
3 Forward/Backward
#16 by viss3n on August 9th, 2011
Quote
3 chanel means…..
#17 by BaDlYbRUiZeD on August 9th, 2011
Quote
I have done some changes in mine fell free to check it out!
I think it looks really cool!
I is a good chopper for begging to take it to the skies!
#18 by tomaszpl69 on August 9th, 2011
Quote
what is the trim? i got mine and it spins out of control wont take off how to fix it?
#19 by CircaMustSurvive on August 9th, 2011
Quote
Mine doesnt take off at all. Its brand new and on a full charge..
#20 by snowman452365 on August 9th, 2011
Quote
plz go to my channel
#21 by doiley11 on August 9th, 2011
Quote
@benwlkn i had the same problem and fixed it by puttting full trim on when both the control and heli are powered on. Turn both off and return the trim to centre. turn both back on and readjust the trim until it stops. you might need to do this a few times to get it right.
#22 by skaterdudet32 on August 9th, 2011
Quote
is it big?
#23 by benwlkn on August 9th, 2011
Quote
i bought one of these yday….i am having trouble adjusting teh trim…no matter how much i adjust it it keeps rotating even when i am just hovering 6ft above ground. The instructions say about screwing a screw on circuitboard somewhere but in very broken english…any ideas to help?
#24 by benwlkn on August 9th, 2011
Quote
i bought one of these yday….i am having trouble adjusting teh trim…no matter how much i adjust it it keeps rotating even when i am just hovering 6ft above ground. The instructions say about screwing a screw on circuitboard somewhere but in very broken english…any ideas to help?
#25 by andybea999 on August 9th, 2011
Quote
I got one of these helicopters yesterday, but I’ve never flown an R/C helicopter of any type before. Any tips?
Thanks